banner



How To Repair A Broken Blind Wand

Introduction

As wand tilt mechanisms age, they can crack and break internally. Instead of replacing the entire window shade or blind, the process of just replacing the broken wand tilt mechanism inside the window bullheaded is quite simple!

The price of a new window blind typically ranges from $eighty-$400. Whereas, only replacing the tilt wand mechanism is $10. Not merely are you saving money, but you will greatly decrease the amount of waste going to the landfill.

  1. Lift up the wand sleeve with your fingers to clear access for the wand to slide out. Once the sleeve is pushed up, rotate the wand horizontally to unhook it from the tilt mechanism. Once the sleeve is pushed up, rotate the wand horizontally to unhook it from the tilt mechanism.

    • Lift upwards the wand sleeve with your fingers to articulate access for the wand to slide out.

    • In one case the sleeve is pushed up, rotate the wand horizontally to unhook information technology from the tilt mechanism.

  2. Lift the header board off the window shade by gently prying up and away from the window blind. Lift the header board off the window shade by gently prying up and away from the window blind.

    • Lift the header lath off the window shade by gently prying upward and away from the window bullheaded.

  3. Unhook the end clips on the window blind by pulling with your fingers toward yourself in an upward motion. Unhook the end clips on the window blind by pulling with your fingers toward yourself in an upward motion. Unhook the end clips on the window blind by pulling with your fingers toward yourself in an upward motion.

    • Unhook the cease clips on the window blind by pulling with your fingers toward yourself in an upwardly motion.

  4. Remove the window blind by pulling it away from the brackets. Remove the window blind by pulling it away from the brackets.

    • Remove the window blind by pulling it away from the brackets.

  5. Slide the end cap off the header to allow for more access. Lift the center rod in an upward motion to unlock it from the header. Lift the center rod in an upward motion to unlock it from the header.

    • Slide the end cap off the header to allow for more than access.

    • Lift the heart rod in an upwards motion to unlock information technology from the header.

  6. Remove the tilt wand mechanism by sliding it off the center rod. Remove the tilt wand mechanism by sliding it off the center rod. Remove the tilt wand mechanism by sliding it off the center rod.

    • Remove the tilt wand mechanism by sliding it off the middle rod.

  7. Install the new tilt wand mechanism by sliding it on the center rod. Once slid into position, reinsert the center rod by pushing down on the assembly. Once slid into position, reinsert the center rod by pushing down on the assembly.

    • Install the new tilt wand mechanism past sliding it on the heart rod.

    • Once slid into position, reinsert the center rod by pushing down on the assembly.

  8. Visually inspect alignment, fitment, and proper function of the newly installed tilt wand mechanism.

    • Visually inspect alignment, fitment, and proper part of the newly installed tilt wand mechanism.

    • Insure the prune is securely held in place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daniel Resch

Fellow member since: 01/06/2021

187 Reputation

one Guide authored

Team

0 Comments

Source: https://www.ifixit.com/Guide/How+to+Replace+a+Broken+Window+Wand+Tilt+Mechanism/140715

Posted by: majortindrithe.blogspot.com

0 Response to "How To Repair A Broken Blind Wand"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel